Cub Cadet I-Beam Style - Manual (Page 60)

3-41
3
14.Remove the wheel shaft assembly, Part No.
611-0023, along with washer and spacer. See
Figure 3-102.
15.Remove the washer, spacer, gear idler assem-
bly, and spacer from the jackshaft. See Figure
3-103.
16.Lift the large spacer off the 10 tooth spur gear.
NOTE
Units produced prior to mid-1994: If rear wheel
drive is periodically lacking, the large spacer,
Part No. 750-0987, should be installed. See
Figure 3-104.
17.Lift the drive shaft assembly until the shift fork
is removed from the clutch collar. See Figure
3-105.
18.Remove the complete drive shaft assembly,
Part No. 611-0015, along with chain and
sprocket. See Figure 3-106.
Tillers.fm Page 41 Tuesday, February 19, 2002 1:28 PM