Cub Cadet I-Beam Style - Manual (Page 120)

4-11
4
5. Remove center bolt from impeller and pull
impeller assembly off crankshaft.
6. The clevis pins can then be removed by tap-
ping out spring roll pin from first spacer. Be
sure to note direction of the flail edges and
catch spacers and washers as you pull clevis
pins from impeller assembly.
7. The flails may now be turned around or
replaced.
8. If for some reason the engine has to be
removed, it can now be removed by taking out
mounting bolts and leaving the rear impeller
housing attached to the engine mounting
base frame.
9. Reassemble in reverse order.
CHIPPER SHREDDER VACUUM.fm Page 11 Tuesday, February 19, 2002 2:19 PM