Cub Cadet I-Beam Style - Manual (Page 38)

3-21
3
3-5.3 Tine Width Adjustment.
1.The tilling width before adjustment is 22
inches. See Figure 3-43.
2.The tilling width can be increased to 24 inches
by removing the clevis pins and hairpin clips.
Sliding the outer tines out 1-inch and securing
in this position with clevis pins and hairpin
clips. See Figure 3-44.
3.For cultivation, reduce the tine width to 13
inches by removing the outer tines completely.
See Figure 3-45.
3-5.4 Forward Clutch Control Cable Attachment.
Attach the end of the forward cable to bracket
underneath handle assembly as follows:
NOTE
The forward clutch cable is the cable which is
attached closer to the rear of the tiller. If the
spring has come loose, reattach.
1.Loosen hex nut on threaded rod near the end
of cable, and move it up the rod as far as it will
go.
2.Unthread rod from the rest of the cable. Hook
Z end of rod into bracket underneath handle
assembly.
CAUTION
Do not overtighten control cable. Too much
tension may cause it to break when engaged.
3.Thread rod back into cable until cable is
straight. Do not tighten it enough to put any
tension on spring.
4.Thread hex nut down against the end of cable
to lock rod in this position.
Tillers.fm Page 21 Tuesday, February 19, 2002 1:28 PM