Cub Cadet I-Beam Style - Manual (Page 11)

2-2
2. Remove belt guard at spindle assembly by
removing two hex bolts, lock washers and hex
nuts. See Figure 2-4.
3. Remove old belt and reassemble with new
belt, part number 754-0142.
NOTE
While the belt cover is removed, it is a good
idea to apply a little grease to the pivot point on
belt cover.
2-1.3 Blade Plane Adjustment.
1. The cutting blade can be adjusted to eight
positions from vertical to horizontal. To adjust,
release adjustment lever on pivot bracket and
rotate spindle housing. Place adjustment lever
in notch desired. See Figure 2-5.
CAUTION
If wheels are not adjusted, the blade will hit the
left front wheel causing the belt to slip.
2. When the blade is adjusted toward the hori-
zontal position, the front wheels must also be
adjusted. Remove two hairpin clips and slide
spacer and wheel to the right. Reinsert hairpin
clips.
Chore Performers.fm Page 2 Wednesday, February 20, 2002 10:25 AM