beautypg.com

Cub Cadet I-Beam Style User Manual

Page 174

background image

5-35

5

6.

Assemble new friction wheel so the cupped
side is towards friction wheel adapter.

7.

Fasten friction wheel to friction wheel adapter
with three lock washers and hex nuts. Tighten
each nut in rotation until they are finger tight.
Spin wheel to see that it is not cocked on hub.
Then tighten using two 1/2 inch wrenches.

8.

Replace rear cover.

5-6.5

Belt Removal and Replacement. Remove
and replace belt as follows:

1.

Remove chute crank at chute assembly by
removing cotter pin and flat washer.

2.

Remove plastic belt cover on the front of
engine by removing three self-tapping screws
and flat washers. See Figure 5-56.

3.

Remove large shoulder bolt and spacer on
right hand side of engine pulley with an adjust-
able wrench. Remove shoulder bolt and
spacer from idler bracket assembly with one
hand. Use the other hand to catch belleville
washer which is on shoulder bolt between idler
bracket and engine plate. See Figure 5-57.

4.

Slip auger drive belt (front belt) off engine pul-
ley. See Figure 5-58.

5.

Remove top screws and lock washers which
attach auger housing assembly to the frame
assembly. A 9/16 inch wrench is required. See
Figure 5-59.

SNOW THROWER.fm Page 35 Wednesday, February 20, 2002 10:28 AM