Cub Cadet I-Beam Style - Manual (Page 151)

5-12
5-1.4 Belt Adjustment.
NOTE
Periodic adjustment of belt tension may be
required due to normal stretch and wear on the
belt. Adjustment is needed if augers seem to
hesitate while turning but the engine main-
tains the same speed.
1. Remove belt cover.
2. There are three adjustment holes provided in
the idler brake bracket assembly for belt ten-
sion adjustment. The front three holes are for
Model 191, and the rear three holes are for
Models 180 and 181. Move extension spring
on the end of the clutch cable to the next
higher adjustment position on idler brake
bracket assembly. See Figure 5-8.
3. Reassemble belt cover.
SNOW THROWER.fm Page 12 Wednesday, February 20, 2002 10:28 AM