Cub Cadet I-Beam Style - Manual (Page 90)

3-71
3
a.Fix: Secure the input pulley using a hex bolt,
lock washer, and flat washer.
9.Does the input pulley rotate the input shaft?
See Figure 3-201.
a.Fix: Remove the input pulley and inspect the
engagement splines. If worn, replace the input
pulley.
10.When the indicator bracket is locked into a
wheel drive and tine rotation position, and the
input pulley is rotated, does the tine shaft
assembly rotate with the drive shaft assembly?
See Figure 3-202.
a.Fix: Proceed to the Interior Gear Case Assem-
bly Inspection.
11.With the spring pin and indicator bracket
removed, does the shift lever have a snap ring
securing it in place? See Figure 3-203.
CAUTION
Internal damage may have occurred to the
shift lever because of the missing snap ring.
a.Fix: Replace the snap ring and run through all
the gear selector positions. Test the unit in nor-
mal operating conditions, to make certain inter-
nal damage did not occur. If damaged, pro-
ceed to the Interior Gear Case Assembly
Inspection section.
Interior Gear Case Assembly Inspection
Tillers.fm Page 71 Tuesday, February 19, 2002 1:28 PM