Cub Cadet I-Beam Style - Manual (Page 69)

3-50
20.Remove wheels from wheel shaft by removing
hex bolt and belleville washer. See Figure 3-
133.
21.Remove V-pulley by removing hex bolt and flat
washer. Hold pulley with belt. See Figure 3-
134.
22.Remove two tine shield mounting brackets
from chain case.
23.Remove belt cover mounting bracket from
chain case.
24.Remove two engine mounting rails from chain
case.
3-9.5 If you get a tiller that is hard to roll on a floor,
you can loosen the three jackshaft bolts and
roll the tiller back and forth to help align the
gears. Tighten nuts when finished. This also
will help shorten break in time for the chain
case.
3-9.6 Disassembly of Chain Case.
1.Remove twelve self-tapping screws from
around the outside edge of chain case. See
Figure 3-135.
Tillers.fm Page 50 Tuesday, February 19, 2002 1:28 PM