Cub Cadet I-Beam Style - Manual (Page 74)

3-55
3
Depth Stake Installation
1.Tilt the tiller forward and rest it on the front
counterweight.
2.Locate the depth stake and remove the “T”
knob, flat washer, and hex bolt from the depth
stake. See Figure 3-152.
3.Remove the clevis pin and hairpin from the
depth stake.
4.Raise the tine shield hinge flap and insert the
depth stake (from below) up through the rear of
the upper tine shield directly in front of the
spacer. See Figure 3-153.
NOTE
Make certain the depth stake is inserted with
the “L” portion facing rearward.
5. Secure the depth stake to the depth stake
bracket using the clevis pin and hairpin
removed earlier.
NOTE
Insert the clevis pin from right to left, through
the second hole from the top of the depth
stake.
6.Insert the hex bolt from the left, through the top
hole of the depth stake, and secure it from the
right using the flat washer and “T” knob
removed earlier.
7.Slowly lower the tiller rearward until it is resting
on the depth stake.
Handle Installation
1.Remove both hex cap screws and flange lock
nuts from the handle brackets using two 1/2"
wrenches and two 9/16” wrenches. See Figure
3-154.
Tillers.fm Page 55 Tuesday, February 19, 2002 1:28 PM