Cub Cadet I-Beam Style - Manual (Page 59)

3-40
9.Split the housing and remove the upper half by
sliding evenly over the wheel and tines shafts.
See Figure 3-97.
10.Remove the gasket. See Figure 3-98.
11.Remove the two washers and the 45 tooth
gear. See Figure 3-99.
12.Remove the sprocket assembly simulta-
neously with the tine shaft assembly and roller
chain. See FIgure 3-100.
NOTE
The welded side of the tine shaft sprocket is on
the bottom.
13.Remove the cup spacer and flat washer from
the tine shaft. See Figure 3-101.
Tillers.fm Page 40 Tuesday, February 19, 2002 1:28 PM