Cub Cadet I-Beam Style - Manual (Page 58)

3-39
3
2.Inspect and clean the tine shaft and wheel
shaft. Polish to remove any nicks or burrs. See
Figure 3-90.
3.Remove the 17—1/4-20 taptite screws. See
Figure 3-91.
4.Remove the 7/16-14 hex nut and bell washer.
See Figure 3-92.
5.Remove the reinforcement bracket and flat
washer. See Figure 3-93.
6.Remove the cover support. See Figure 3-94.
7.Remove the cover support brackets. See Fig-
ure 3-95.
8.Remove the cable support bracket. See Figure
3-96.
Tillers.fm Page 39 Tuesday, February 19, 2002 1:28 PM