Cub Cadet I-Beam Style - Manual (Page 30)

3-14
6.Reassemble the new belt following instructions
in reverse order.
3-4.2 Re ve rse Drive Belt Removal and Replace-
ment.
1.To remove reverse drive belt, first remove for-
ward drive belt as instructed in the previous
paragraph.
2.Remove reverse drive belt from beneath belt
retainer.
3. Roll belt off transmission pulley. Remove it
from beneath forward idler bracket. See Figure
3-29.
4.Remove hex nut which secures reverse idler
pulley to idler bracket. Slide idler pulley out and
remove belt. See Figure 3-30.
NOTE
Make certain reverse drive belt is assembled
with the wide side of the belt against transmis-
sion and engine pulleys.
5.Reassemble new belt following instructions in
reverse order.
3-4.3 Disassembly of Tine Chain Case.
Disassemble as follows:
1.Remove chain case from tiller.
2.Remove self-tapping screws, hex bolts, lock
washers and hex nuts from the outer edge of
chain case.
3.Remove hex bolt, lock washers, and hex nut
from center of the chain case. See Figure 3-31.
4.Remove self-tapping screws from bearing
housing. See Figure 3-32.
5.Slide bearing housing and bearing off input
shaft.
6.Separate the halves of chain case housing. Be
careful not to damage chain case gasket.
Replace if necessary. See Figure 3-33.
Tillers.fm Page 14 Tuesday, February 19, 2002 1:28 PM