Cub Cadet I-Beam Style - Manual (Page 101)

3-82
2.Remove both self tapping washer head screws
securing the gear positioner bracket to the
gear case assembly using a 3/8” socket. See
Figure 3-239.
3.Remove the hex nut and bell washer securing
the jack shaft assembly to the gear case
assembly using an 11/16” socket.
4.Remove the shoulder nut securing the idler
bracket to the gear case assembly using a 7/8”
socket.
5.Remove the idler bracket assembly.
6.Remove the gear positioner bracket from the
gear case.
7.Remove both self tapping washer head screws
securing the shift cover bracket to the gear
case using a 3/8” socket. See Figure 3-240.
8.Remove the hex nut and bell washer securing
the wheel input sprocket assembly to the gear
case using an 11/16” socket.
9.Remove the hex nut and lock washer securing
the belt cover bracket using a 1/2" socket.
NOTE
Bracket looks like a “U” when installed cor-
rectly.
10.Remove all hex bolts and flange nuts using a
1/2" socket and a 1/2" wrench. See Figure 3-
241.
11.Remove all large self tapping screws using a
1/2" socket.
12. Remove all remaining perimeter self tapping
screws using a 3/8” socket.
Tillers.fm Page 82 Tuesday, February 19, 2002 1:28 PM