Cub Cadet I-Beam Style - Manual (Page 68)

3-49
3
16.Remove eight bolts, lock washers and hex
nuts at front bottom edge of tine shield and
reinforcement bracket. Lift off tine shield. See
Figure 3-129.
17.Remove tine assemblies from tine shaft on
chain case by removing clevis pin and hairpin
cotters. Slide tine assemblies off tine shaft.
See Figure 3-130.
18.Remove drive belt by holding the belt tight
(close to the engine). Remove hex bolt, lock
washer, flat washer and spacer at engine pul-
ley. Slide one half of split belt off. See Figure 3-
131.
19.To remove engine from engine mounting rails,
remove four hex bolts, lock washers and hex
nuts. See Figure 3-132.
Tillers.fm Page 49 Tuesday, February 19, 2002 1:28 PM