Cub Cadet I-Beam Style - Manual (Page 176)

5-37
5
NOTE
Shoulder of the bolt must go through both
sides of idler bracket assembly.
8. Reassemble belt cover and chute crank.
5-6.7 Drive Belt Removal. To remove drive belt,
proceed as follows:
1. Remove cotter pin which holds linkage rod to
idler bracket assembly.
2. Unhook extension spring from engine plate.
See Figure 5-62.
3. Remove drive belt from engine pulley and bot-
tom drive pulley.
4. Replace belt and reassemble in reverse order.
5-7. 33-INCH SNOW THROWER MODEL 960
(See Figure 5-63).
5-7.1 Model Specifications. For a summary of
specifications, see Table 5-3.
5-7.2 Drive clutch adjustment. Refer to Models 840
and 850 in paragraph 5-6.1.
5-7.3 Auger clutch adjustment. Refer to Models 840
and 850 in paragraph 5-6.1.
5-7.4 Shift rod adjustment. Refer to Models 840 and
850 in paragraph 5-6.3.
5-7.5 Changing the friction wheel. Refer to Models
840 and 850 in paragraph 5-6.4. See Figure 5-
55.
SNOW THROWER.fm Page 37 Wednesday, February 20, 2002 10:28 AM