CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 96)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 96 of 350
MIB retrieval: not supported
MTU Size: 1518
Operational status:
Port status: operational
Loopback status: no loopback
PDU revision: 1
Remote client:
-----------------
MAC address: 0002.b33e.401d
Vendor(oui): 3 0 50
Administrative configurations:
Mode: active
Unidirection: supported
Link monitor: supported
Remote Loopback: supported
MIB retrieval: not supported
MTU Size: 1518
Remote Loopback Configuration
We must enable Ethernet OAM remote loopback on an interface for the local OAM client to initiate OAM
remote loopback operations. It is disabled by default.
Bridge1
DUT# configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-9 Specify the interface (eth-0-9)to be
configured and enter the Interface
mode
DUT(config-if)# ethernet oam remote loopback supported Enable Ethernet remote loopback on
eth-0-9.
DUT(config-if)# ethernet oam remote loopback start Turn on remote-loopback on eth-0-9
DUT(config-if)# ethernet oam remote loopback stop Turn off remote-loopback on eth-0-9
DUT(config-if)# end Exit the Interface mode.