CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 245)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 245 of 350
30 Configuring MPLS OAM
This chapter contains configuration for MPLS Operations, Administration and Management
(OAM). MPLS OAM is used to detect forwarding plane failures in an MPLS network.
Similar to ICMP echo requests and replies in an IP network, an MPLS network can have MPLS
echo requests and replies for checking the data plane and control plane operations in the Label
Switched Path (LSP). The MPLS traceroute process also provides path details for the LSP.
30.1 Validating an LDP IPv4 FEC by Using MPLS LSP Ping
and MPLS LSP Traceroute:
30.1.1 Configurations on PE1
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)# enable-ldp Configure Interface for LDP
DUT1(config-if)# ip address
1.1.1.1/24
Create IP address on the port.
DUT1(config)#exit Exit the Interface mode.
DUT1(config)# interface eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)# enable-ldp Configure Interface for LDP
DUT1(config-if)# ip address
2.2.2.1/24
Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)# exit Exit the router-ldp mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)# network
1.1.1.0/24 Associate networks with the RIP
process.