CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 281)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 281 of 350
The following example shows mapping priority 63 color green to DSCP 60, and replace DSCP in
the interface eth-0-1 egress.
DUT# configure terminal
DUT(config)# qos map pri-color-dscp 63 green to 60
DUT(config)# interface eth-0-1
DUT(config-if)# replace dscp
31.2.3 Verify QoS Information
Use the following commands to verify QoS information.
Class Maps information
The show class-map command displays the QoS class-maps to define the match criteria to
classify traffic.
DUT#show class-map cmp1
CLASS-MAP-NAME: cmp1
match access-group: ip_acl1
match access-group: ip_acl2
DUT#
Aggregate Policer information
The show qos aggregate-policer command displays the aggregate policer configuration.
DUT#show qos aggregate-policer agg_plc
AGGREGATOR-POLICER-NAME: agg_plc
CIR 3242234 kbps, CBS 40000 bytes, EBS 40000 bytes, color aware mode, drop color
is red use-l3-length
DUT#
Policy-Map information
The show policy-map command displays QoS policy-map information.
DUT#show policy-map p-1
POLICY-MAP-NAME: p-1
State: attached