CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 235)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 235 of 350
DUT1(config)#interface eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the
interface
DUT1(config)#no switchport Configure the port to layer 3
port.
DUT1(config-if)#ip address
11.11.17.3/24 Create IP address on the port.
DUT1(config-if)#enable-ldp Configure Interface for LDP.
DUT1(config-if)#label-switching Enable label-switching on
interface.
DUT1(config-if)#exit Exit the Interface mode
DUT1(config)# interface loopback 0 Enter the Interface mode.
• loopback0—Specify the
loopback interface name.
DUT1(config-if)#ip address
11.11.3.3/32 Create loopback addresses on
both PE routers. Use a /32 host
route for the loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#transport-address
11.11.3.3 Configure the transport
address for a label space.
DUT1(config-router)#targeted-peer
11.11.1.1 Configure Targeted Peer.
DUT1(config-router)#targeted-peer
11.11.4.4 Configure Targeted Peer.
DUT1(config)#exit Exit the router-ldp mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)#network
11.11.1.1/16 Associate networks with the
RIP process.
DUT1(config-router)# exit Exit the router-rip mode.
DUT1(config)#mpls vpls-vlan 4000
4010 Create a block of continuous
vlan id which used for vpls
function.
DUT1(config)#mpls vpls v3 100 Create a VPLS instance and