CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 240)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 240 of 350
14.14.14.2 raw manual
DUT1(config-vpls)#vpls-peer
11.11.11.3 raw manual Add a PE for VPLS instance.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# mpls-vpls
vpls1
Bind an interface to a VPLS
instance.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-vpls
vpls1 vlan 100 Bind an interface to a VPLS
instance.
DUT1(config)#vpls-fib-add
vpls1 peer 14.14.14.2 102 201 Bind an interface to a VPLS
instance.
DUT1(config)#vpls-fib-add
vpls1 peer 11.11.11.3 103 301 Bind an interface to a VPLS
instance.
Configuring the VPLS on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config)#switchport mode
trunk Configure trunk mode on the port.
DUT1(config)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address
12.12.12.2/24 Create IP address on the port.
DUT1(config-if)# Enable label-switching on interface.