CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 27)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 27 of 350
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-2
Specify the interface (eth-0-2)to be configured and enter the
Interface mode.
DUT1(config-if)# channel-group 1 mode active
Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-3
Specify the interface (eth-0-3)to be configured and enter the
Interface mode.
DUT1(config-if)# channel-group 1 mode active
Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#end Return to privileged EXEC mode.
S2
DUT2#configure terminal Enter the Configure mode.
DUT2(config)# lacp system-priority 1000
Set the system priority of this switch. This priority is
used for determining the system that is responsible
for resolving conflicts in the choice of aggregation
groups. A lower numerical value has a higher priority.
DUT2(config)#interface eth-0-1
Specify the interface (eth-0-1)to be configured and enter the
Interface mode.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)# channel-group 1 mode active
Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT2(config)#interface eth-0-2
Specify the interface (eth-0-2)to be configured and enter the
Interface mode.