CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 159)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 159 of 350
Preempt mode : TRUE
Auth type : NONE
Conf pri : Unset Run pri : 255
R1#show vrrp 2
VRID <2>
State : Backup
Virtual IP : 10.10.10.82(Not IP owner)
Interface : eth-0-1
VMAC : 0000.5e00.0102
Advt timer : 5
Preempt mode : TRUE
Auth type : NONE
Conf pri : 200 Run pri : 200
R2#show vrrp 1
VRID <1>
State : Backup
Virtual IP : 10.10.10.81(Not IP owner)
Interface : eth-0-1
VMAC : 0000.5e00.0101
Advt timer : 5
Preempt mode : TRUE
Auth type : NONE
Conf pri : 200 Run pri : 200
R2#show vrrp 2
VRID <2>
State : Master
Virtual IP : 10.10.10.82(IP owner)
Interface : eth-0-1
VMAC : 0000.5e00.0102
Advt timer : 5
Preempt mode : TRUE
Auth type : NONE
Conf pri : Unset Run pri : 255
VRRP Circuit Failover
The need for VRRP Circuit Failover arose because VRRPv2 was unable to track the gateway
interface status. The VRRP Circuit Failover feature provides a dynamic failover of an entire
circuit in the event that one member of the group fails. It introduces the concept of a circuit,