CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 23)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 23 of 350
DUT1(config-if)#static-channel-group 1
Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-7
Specify the interface (eth-0-7)to be configured and enter the
Interface mode.
DUT1(config-if)#static-channel-group 1
Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#end Return to privileged EXEC mode.
DUT1#show channel-group summary Verify the configuration.
2.1.2 Validation Commands
DUT1#show channel-group summary
Flags: D - down/admin down B - in Bundle
R - Layer3 S - Layer2
U - in use
Aggregator Name Protocol Ports
----------------+------------+--------------------------------------------
agg1(SU) Static eth-0-5(B) eth-0-7(D) eth-0-6(B)
DUT1#
DUT1#show interface agg1
Interface agg1
Interface current state: UP
Hardware is AGGREGATE, address is 1e24.0c97.0905 (bia 1e24.0c97.0905)
Bandwidth 2000000 kbits
Index 155 , Metric 1 , Encapsulation ARPA
Speed - 1000Mb/s , Duplex - Full , Media type is Link Aggregation
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off