CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 145)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 145 of 350
DUT(config-router)#neighbor 10.10.10.10
update-source loopback 0
Configure the loopback 0 to be the update-source interface
DUT(config-router)#redistribute connected Redistribute the connect route into bgp
DUT(config-router)#exit Exit the router mode and enter the Configure mode.
18.3.4 Experiment Results
(3) Switch A output
DUT#show ip bgp neighbors
BGP neighbor is 11.11.11.11, remote AS 100, local AS 100, internal link
BGP version 4, remote router ID 11.11.11.11
BGP state = Established, up for 00:10:52
Last read 00:10:52, hold time is 180, keepalive interval is 60 seconds
Neighbor capabilities:
Route refresh: advertised and received (old and new)
Address family IPv4 Unicast: advertised and received
Received 14 messages, 0 notifications, 0 in queue
Sent 18 messages, 0 notifications, 0 in queue
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 5 seconds
Update source is loopback0
For address family: IPv4 Unicast
BGP table version 12, neighbor version 12
Index 1, Offset 0, Mask 0x2
Community attribute sent to this neighbor (both)
2 accepted prefixes
6 announced prefixes
Connections established 1; dropped 0
Local host: 10.10.10.10, Local port: 179
Foreign host: 11.11.11.11, Foreign port: 48662