CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 21)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 21 of 350
1.3.2 Configurations
Bridge 1
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-1 Enter the interface mode.
DUT(config-if)#duplex full Set interface eth-0-1 duplex to full.
DUT(config-if)#interface eth-0-2 Enter the interface eth-0-2.
DUT(config-if)#duplex half Set interface eth-0-2 duplex to half.
DUT(config-if)#interface eth-0-3 Enter the interface eth-0-3.
DUT(config-if)#duplex auto Set interface eth-0-3 duplex to auto negotiation.
DUT(config)#end Exit to exec mode.
DUT#show interface status Display interface duplex.
1.3.3 Validation Commands
Bridge 1
DUT#show interface status
Port Status Duplex Speed Mode Type
------------------------------------------------------------
eth-0-1 up full a-1000 access 1000BASE_T
eth-0-2 up half a-100 access 1000BASE_T
eth-0-3 up a-full a-1000 access 1000BASE_T