CANOGA PERKINS CanogaOS Configuration Guide User Manual

Page 44

CanogaOS Configuration Guide

Proprietary & Confidential Canoga Perkins Metro Ethernet Switches

Page 44 of 350

Note: This configuration sample assumes that you are running the Layer-2 module. If you
are using the Layer-2 module, run the switchport command on each port to set the
switching characteristics of Layer-2 protocols.

Bridge1

DUT# configure terminal

Enter the Configure mode.

DUT(config)# spanning-tree mode rstp

Configure a spanning-tree mode.

DUT(config)# spanning-tree priority 4096

Configure the switch priority,the default
is 32768.

DUT(config)# interface eth-0-1

Specify the interface (eth-0-1)to be
configured and enter the Interface mode

DUT(config-if)# spanning-tree path-cost 200

Configure the cost for an interface.

DUT(config-if)# exit

Exit the Interface mode and enter the
Configure mode.

DUT(config)# interface eth-0-4

Specify the interface (eth-0-4)to be
configured and enter the Interface mode

DUT(config-if)# spanning-tree port-priority 64

Configure the port priority for an
interface, the default is 128.

DUT(config-if)# exit

Exit the Interface mode and enter the
Configure mode.

DUT(config)# spanning-tree enable

Enable spanning tree protocol.

The default is enable

Bridge 2