CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 257)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 257 of 350
interface
DUT1(config-if)#no switchport Configure the port to layer
3 port.
DUT1(config-if)#ip vrf forwarding vpn1 Associate a VPN routing
and
forwarding(VRF)instance
with an Layer3 interface.
DUT1(config-if)#ip address 1.1.1.1/24 Create IP address on the
port.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)# network
10.10.10.10/32 Associate networks with
the RIP process.
DUT1(config-router)# network 2.2.2.0/24 Associate networks with
the RIP process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls enable-all-interfaces Enable label-switching on
all interfaces.
DUT1(config)#router bgp 1 Configure a BGP routing
process.
DUT1(config-router)#bgp router-id
10.10.10.10 Configure the router
identifier.
DUT1(config-router)#neighbor 11.11.11.11
remote-as 1 Configure an internal or
external BGP (iBGP or
eBGP) TCP session with
another router.
DUT1(config-router)#neighbor 11.11.11.11
update-source loopback0 Allow internal BGP
sessions to use any
operational interface for
TCP connections.
DUT1(config-router)#address-family vpnv4
unicast Enter the VPNv4
address-family command
mode.
DUT1(config-router-af)#neighbor
11.11.11.11 activate Enable the exchange of the
specified AF routes with a
neighboring router.
DUT1(config-router-af)#neighbor Specify that a community