CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 254)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 254 of 350
vc1 100 10.10.10.10 routers must be configured with the
same VC-ID.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)#mpls-l2-circuit
vc1 Bind an interface to the Virtual
Circuit.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#router rip Enter the router-rip mode
DUT1(config-router)#network
4.4.4.0/24 Associate networks with the RIP
process.
DUT1(config-router)#network
11.11.11.11/32 Associate networks with the RIP
process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls
enable-all-interfaces Enable label-switching on all
interfaces.
30.2.5 Validation Commands
The validation commands used are show mpls ftn-forwarding, show mpls l2-circuit,
show mpls vc-table, ping mpls l2-circuit and traceroute mpls l2-circuit on PE1.
DUT1# show mpls ftn-forwarding
FEC Out-Label Nexthop Out-Intf
3.3.3.0/24 3 2.2.2.2 eth-0-12
4.4.4.0/24 1025 2.2.2.2 eth-0-12
11.11.11.11/32 1026 2.2.2.2 eth-0-12
DUT1# show mpls l2-circuit
VC-Name VC-ID Interface VC-type VLAN C-Word Manual
vc1 100 eth-0-1 Ethernet N/A 0 No
DUT1# show mpls vc-table
VC-ID PW Intf AC Intf L/R Label EndPoint Status Manual
100 eth-0-12 eth-0-1 1024/1024 11.11.11.11 Active No
DUT1# ping mpls l2-circuit 100 source 10.10.10.10
Sending 5 MPLS Echos to VC Id : 100, timeout is 5 seconds
Codes:
'!' - Success, 'Q' - request not sent, '.' - timeout,