CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 226)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 226 of 350
200 192.168.11.10 same VC-ID (200).
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address
8.8.8.1/24 Create IP address on the port.
DUT1(config-if)# enable ldp Configure Interface for LDP
DUT1(config-if)#
label-switching Enable label-switching on interface
28.1.2 Configuring the VPWS on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-l2-circuit
t1 ethernet Bind an interface to the Virtual
Circuit.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# interface
loopback 0
Enter the Interface mode.
• loopback0—Specify the loopback
interface name.
DUT1(config-if)#ip address
192.168.11.10/32 Create loopback addresses on both
PE routers. Use a /32 host route for
the loopback address.
DUT1(config)#exit Exit the Configure mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#
targeted-peer 192.168.10.10 Configure Targeted Peer in LDP.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)# mpls l2-circuit
t1 200 192.168.10.10 Create a Virtual Circuit.Both PE
routers must be configured with the
same VC-ID (200).