CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 253)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 253 of 350
DUT1(config)#router rip Enter the router-rip mode
DUT1(config-router)#network
4.4.4.0/24 Associate networks with the RIP
process.
DUT1(config-router)#network
3.3.3.0/24 Associate networks with the RIP
process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls
enable-all-interfaces Enable label-switching on all
interfaces.
30.2.4 Configurations on PE4
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-9 Enter the Interface mode.
• eth-0-9—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address
4.4.4.2/24 Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)#interface
loopback 0 Enter the Interface mode.
• loopback0—Specify the loopback
interface name.
DUT1(config-if)#ip address
11.11.11.11/32 Create loopback addresses on both
PE routers. Use a /32 host route for
the loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#
targeted-peer 10.10.10.10 Configure Targeted Peer in LDP.
DUT1(config-router)#
transport-address 11.11.11.11 Configure Transport Address in
LDP.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#mpls l2-circuit Create a Virtual Circuit.Both PE