CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 243)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 243 of 350
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the
interface
DUT1(config)#no switchport Configure the port to layer 3
port.
DUT1(config-if)#ip address
11.11.11.4/24 Create IP address on the port.
DUT1(config-if)#label-switching Enable label-switching on
interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the
interface
DUT1(config)#no switchport Configure the port to layer 3
port.
DUT1(config-if)#ip address
12.12.12.4/24 Create IP address on the port.
DUT1(config-if)#label-switching Enable label-switching on
interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-3 Enter the Interface mode.
• eth-0-3—Specify the
interface
DUT1(config)#no switchport Configure the port to layer 3
port.
DUT1(config-if)#ip address
13.13.13.4/24 Create IP address on the port.
DUT1(config-if)#label-switching Enable label-switching on
interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# mpls ilm-entry php
130 11.11.11.3 Configure one static ILM
entry.
DUT1(config)# mpls ilm-entry php
230 11.11.11.3 Configure one static ILM
entry.