CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 229)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 229 of 350
t2 ethernet Circuit.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# interface
loopback 0
Enter the Interface mode.
• loopback0—Specify the loopback
interface name.
DUT1(config-if)#ip address
192.168.11.10/32 Create loopback addresses on both
PE routers. Use a /32 host route for
the loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls ftn-entry
192.168.10.1/24 222 8.8.8.1 Configure FTN entry for tunnel
DUT1(config)#mpls ilm-entry
pop 111 Configure ILM entry for tunnel
DUT1(config)#mpls l2-circuit t2
201 192.168.10.10 manual Create a Virtual Circuit.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address
8.8.8.2/24 Create IP address on the port.
DUT1(config-if)#
label-switching Enable label-switching on interface
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls
l2-circuit-fib-entry t2 333 444 Configure VC label for the VC
28.2.3 Validation Commands
Use the show mpls l2-circuit and the show mpls vc-table commands respectively to display
complete information about the Layer-2 Virtual Circuit. The following are the sample outputs for
the show commands displaying Layer-2 virtual circuit information.
1) on PE1
DUT1#show mpls l2-circuit
VC-Name VC-ID Interface VC-type VLAN C-Word Manual
t2 200 eth-0-1 Ethernet N/A 0 Yes