CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 187)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 187 of 350
Topology
Configurations
Router 1
DUT1>enable Enter Privilege Exec mode
DUT1#configure terminal Enter Configuration mode
DUT1(config)# ip pim bsr-candidate eth-0-1 Configure eth-0-1 of rtr1 as C-BSR. The
default priority is 64.
Router 2
DUT2>enable Enter Privilege Exec mode
DUT2#configure terminal Enter Configuration mode
DUT2(config)# ip pim bsr-candidate eth-0-1 10 25 Configure eth-0-1 of rtr2 as C-BSR with a
hash mask length 10 and a priority of 25.
DUT2(config)#ip pim rp-candidate eth-0-1 priority 0 Configure interface eth-0-1 as C-RP with a
priority of 0.
Router 2 Unicast BSM
When the command ip pim unicast-bsm is configured on an interface which is a DR for that
network, then that interface will unicast the stored copy of BSM to new/rebooting router.
When the command ip pim unicast-bsm is
configured on an interface which is a DR for
that network, then that interface will unicast
the stored copy of BSM to new/rebooting
router.
DUT>enable
Enter Privilege Exec mode
DUT#configure terminal Enter Configuration mode
DUT(config)# interface eth-0-1 Enter interface mode
Router 1 Router 2 Eth-0-1 Eth-0-1
Eth-0-2 Eth-0-2