CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 316)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 316 of 350
DUT(config-if)# no switchport Configure the port as layer3 routed port
DUT(config-if)# ip address
202.38.100.1/24 Set the IP address for the routed port
Configuring the Switch-to-RADIUS-Server Communication
RADIUS security servers are identified by their host name or IP address, host name and specific
UDP port numbers, or IP address and specific UDP port numbers. The combination of the IP
address and UDP port number creates a unique identifier, which enables RADIUS requests to be
sent to multiple UDP ports on a server at the same IP address. If two different host entries on the
same RADIUS server are configured for the same service—for example, authentication—the
second host entry configured acts as the fail-over backup to the first one. The RADIUS host
entries are tried in the order that they were configured. In this release, up to 3 RADIUS server
can be configured.
DUT# configure terminal Enter the Configure mode.
DUT(config)#radius-server host
202.38.100.7 key test retransmit 3
timeout 5 auth-port 1812 Configure the RADIUS server parameters on the switch.
The key is a text string that must match the encryption key used
on the RADIUS server.
If you want to use multiple RADIUS servers, re-enter this command.
DUT(config)# radius-server deadtime 5 Specify the server active period, the default is 5 minutes.