CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 45)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 45 of 350
Bridge 3
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree mode rstp Configure a spanning-tree mode.
DUT(config)# spanning-tree priority 32768 Configure the switch priority,the default
is 32768.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge 4
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree mode rstp Configure a spanning-tree mode.
DUT(config)# spanning-tree priority 16384 Configure the switch priority,the default
is 32768.
DUT(config)# interface eth-0-1 Specify the interface (eth-0-1)to be
configured and enter the Interface mode
DUT(config-if)# spanning-tree path-cost 200 Configure the cost for an interface.
DUT(config-if)# exit Exit the Interface mode and enter the
Configure mode.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
7.1.3 Validation Commands
1. Verify the STP port state on Bridge1
DUT#show spanning-tree brief
Rapid spanning tree protocol Enabled
Root ID Priority 4096 (0x1000)
Address 6c92.fe12.4901
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 4096 (0x1000)
Address 6c92.fe12.4901
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300 sec
Interface Role State Cost Priority.Number Type
------------------------------------------------------------------------