CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 241)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 241 of 350
label-switching
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-4 Enter the Interface mode.
• eth-0-4—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address
14.14.14.2/24 Create IP address on the port.
DUT1(config-if)#
label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls ftn-entry
14.14.14.1/32 3 14.14.14.1 Configure one static FTN entry.
DUT1(config)#mpls ftn-entry
11.11.11.3/32 230 12.12.12.4 Configure one static FTN entry.
DUT1(config)# mpls vpls vpls1
1 Create a VPLS instance and come
into the VPLS instance mode.
DUT1(config-vpls)#vpls-peer
14.14.14.1 raw manual Add a PE for VPLS instance.
DUT1(config-vpls)#vpls-peer
11.11.11.3 raw manual Add a PE for VPLS instance.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)#mpls-vpls
vpls1 vlan 200 Bind an interface to a VPLS
instance.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# vpls-fib-add
vpls1 peer 14.14.14.1 201 102
Add a static PW for a PE in a VPLS
instance.
DUT1(config)# vpls-fib-add
vpls1 peer 11.11.11.3 203 302
Add a static PW for a PE in a VPLS
instance.
Configuring the VPLS on PE3
Command Description