CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 50)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 50 of 350
DUT(config-if)# switchport mode trunk Configure eth-0-18 to mode trunk.
DUT(config-if)# switchport trunk allowed vlan all Configure vlans that allowed passing the port.
DUT(config-if)# no shutdown Open the port.
DUT(config-if)# exit Exit interface mode of interface eth-0-18
DUT(config)#exit Exit configuration mode
Bridge1
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree priority 0 Configure CIST priority to 0.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge2
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree instance 1 priority 0 Configure instance 1 priority to 0.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge3
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree instance 2 priority 0 Configure instance 2 priority to 0.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge4
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
8.1.4 Validation Commands
3. Verify the MSTP port state on Bridge1
DUT# show spanning-tree mst brief
##### MST0: Vlans: 1
Multiple spanning tree protocol Enabled