CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 164)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 164 of 350
21.2.2 Configuring the track interface linkstate
Beginning in privileged EXEC mode, follow these steps to configure the track
interface linkstate:
Command Description
DUT#configure terminal Enter the Configure mode.
DUT(config)# track 1
interface eth-0-1 linkstate Create a track object and track the
state of an interface.
DUT(config-track)# delay up
30 (Optional)Configure the track object
parameters:
specify a period of time (in seconds)
to delay when object state is turned
from down to up.
DUT(config-track)# delay
down 30 (Optional)Configure the track object
parameters:
specify a period of time (in seconds)
to delay when object state is turned
from up to down.
DUT(config-track)#exit Exit the track mode.
DUT(config)#exit Exit the Configure mode.
Validation Commands
To display the track interface linkstate configuration, use the show track privileged
EXEC command.
DUT#show track
Track 2
Type : Interface Linkstate
Interface : eth-0-2
State : down
Delay up : 30 seconds
Delay down : 30 seconds
21.2.3 Configuring the track rtr reachability
Beginning in privileged EXEC mode, follow these steps to configure the track rtr
reachability:
Command Description
DUT#configure terminal Enter the Configure mode.
DUT(config)# track 1 rtr 1
reachability Create a track object and track the
state of an ip sla entry.
When the state of ip sla entry is OK