CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 212)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 212 of 350
11.11.1.1/16
configure lsr-b:
Beginning in privileged EXEC mode, follow these steps to configure the LDP:
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the
interface
DUT1(config-if)# no switchport Configuring the port as layer 3
port.
DUT1(config-if)# ip address
11.11.17.2/24 Create IP address on the port.
DUT1(config-if)# enable-ldp Configuring Interface for LDP.
DUT1(config-if)# label-switching Enable label-switching on
interface.
DUT1(config-if)#exit Exit the Configure mode.
DUT1(config)#router ldp Enter the router-ldp mode.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#router rip Enter the router-rip mode.
DUT1(config-router)#network
11.11.1.1/16 Associate networks with the
RIP process.
DUT1(config-router)#exit Exit the router-rip mode
DUT1(config)#interface eth-0-9 Enter the Interface mode.
• eth-0-9—Specify the
interface
DUT1(config-if)#no switchport Configuring the port as layer 3
port.
DUT1(config-if)#ip address
11.11.9.1/24 Create IP address on the port.
DUT1(config-if)#enable-ldp Configuring Interface for LDP.
DUT1(config-if)#label-switching Enable label-switching on
interface.