CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 119)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 119 of 350
17.3 Enabling OSPF on an Interface
This example shows the minimum configuration required for enabling OSPF on an interface. R1
and R2 are two routers in Area 0 connecting to network 10.10.10.0/24.
Note: Configure one interface so that it belongs to only one area. However, you can configure
different interfaces on a router to belong to different areas.
17.3.1 Terminology
17.3.2 Configurations
R1
DUT# configure terminal Enter the Configure mode.
DUT(config)# router ospf 100 Configure the Routing process and specify the Process
ID (100). The Process ID should be a unique positive
integer identifying the routing process.
DUT(config-router)# network 10.10.10.0/24 area 0 Define the interface (10.10.10.0/24) on which OSPF
runs and associate the area ID (0) with the interface
(area ID 0 specifies the backbone area).