CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 213)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 213 of 350
configure lsr-c:
Beginning in privileged EXEC mode, follow these steps to configure the LDP:
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface
eth-0-9 Enter the Interface mode.
• eth-0-9—Specify the interface
DUT1(config-if)# no
switchport Configuring the port as layer 3 port.
DUT1(config-if)# ip address
11.11.9.2/24 Create IP address on the port.
DUT1(config-if)# enable-ldp Configuring Interface for LDP.
DUT1(config-if)#
label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Configure mode.
DUT1(config)#router ldp Enter the router-ldp mode.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#router rip Enter the router-rip mode
DUT1(config-router)#network
11.11.1.1/16 Associate networks with the RIP
process.
Validation Commands
To display the LDP configuration, use the show ldp session privileged EXEC
command.
1) show status lsr-a:
DUT1#show ldp session
Peer IP Address IF Name My Role State KeepAlive
11.11.17.2 eth-0-17 Passive OPERATIONAL 30
2) show status lsr-b:
DUT1#show ldp session
Peer IP Address IF Name My Role State KeepAlive
11.11.9.2 eth-0-9 Active OPERATIONAL 30
11.11.17.1 eth-0-17 Active OPERATIONAL 30
3) show status lsr-c: