CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 121)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 121 of 350
17.4 Setting Priority
This example shows the configuration for setting the priority for an interface. You can set a high
priority for a router to make it the Designated Router (DR). Router R3 is configured to have a
priority of 10, which is higher than the default priority (default priority is 1) of R1 and R2;
making it the DR.
17.4.1 Terminology
17.4.2 Configurations
R3
DUT(config)# interface eth-0-1 Specify the interface (eth-0-1) to be configured.
DUT (config-if)# ip ospf priority 10 Specify the router priority to a higher R3 the Designated
Router (DR).
DUT (config-if)# exit Exit the Interface mode and return to the Configure
mode.
DUT (config)# router ospf 100 Configure the Routing process and specify the Process
ID (100). The Process ID should be a unique positive
integer identifying the routing process.
DUT (config-router)# network 10.10.10.0/24 area 0 Define the interface (10.10.10.0/24) on which OSPF
runs and associate the area ID (0) with the interface.