CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 225)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 225 of 350
28 Configuring VPWS
This chapter describes how to configure VPWS.
The MPLS Layer-2 Virtual Circuit is a point-to-point Layer 2 connection transported by means
of Multiprotocol Label Switching (MPLS) on the service provider’s network. The Layer 2 circuit
is transported over a single Label Switched Path (LSP) tunnel between two Provider Edge (PE)
routers.
28.1 Configuring VPWS using LDP
The Virtual Circuit module is a part of the LDP module. It is based on the IETF drafts proposed
by Martini, et al [L2TRANS]. The Virtual Circuits module sets up virtual circuits for
transporting Layer 2 protocols across an MPLS network. This chapter includes a step-by-step
configuration of VPWS.
28.1.1 Configuring the VPWS on PE1
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-l2-circuit
t1 ethernet Bind an interface to the Virtual
Circuit.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# interface
loopback 0
Enter the Interface mode.
• loopback0—Specify the loopback
interface name.
DUT1(config-if)#ip address
192.168.10.10/32 Create loopback addresses on both
PE routers. Use a /32 host route for
the loopback address.
DUT1(config)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#
targeted-peer 192.168.11.10 Configure Targeted Peer in LDP.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#mpls l2-circuit t1 Create a Virtual Circuit.Both PE
routers must be configured with the