CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 158)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 158 of 350
R2
DUT# configure terminal
Enter the Configure mode.
DUT(config)#router vrrp 1 Create a new VRRP session on the router and specify the VRID for the
session.
DUT(config-router)#virtual-ip
10.10.10.81 Set the virtual IP address for the VRRP session.
DUT(config-router)#interface eth-0-1 Specify the physical interface that will participate in virtual routing.
DUT(config-router)#priority 200 Configure the priority to 200 (less than 255) as R2 is the Backup router.
DUT(config-router)#preempt-mode true Set the preempt mode to specify that the highest priority will function as
a backup to master when master is unavailable
DUT(config-router)#
advertisement-interval 5 Configure the advertisement interval to 5 seconds.
DUT(config-router)# enable Enable the VRRP session 1 on the router.
DUT(config)# exit Exit Router mode and enter the Configure mode.
DUT(config)#router vrrp 2 Create a new VRRP session on the router and specify the VRID for the
session.
DUT(config-router)#virtual-ip
10.10.10.82 Set the virtual IP address for the VRRP session.
DUT(config-router)#interface eth-0-1 Specify the physical interface that will participate in virtual routing.
DUT(config-router)# preempt-mode true Set the preempt mode to specify that the highest priority will function as
a backup to master when master is unavailable
DUT(config-router)#
advertisement-interval 5 Configure the advertisement interval to 5 seconds.
DUT(config-router)# enable Enable the VRRP session 2 on the router.
Outputs
The following outputs on R1and R2 display the complete configuration for each session on R1
and R2. In session one R1 is the master router and in session 2 R2 is the master router.
R1#show vrrp 1
VRID <1>
State : Master
Virtual IP : 10.10.10.81(IP owner)
Interface : eth-0-1
VMAC : 0000.5e00.0101
Advt timer : 5