CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 130)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 130 of 350
17.8 Configuring Virtual Links
Virtual links are used to connect a temporarily disjointed non-backbone area to the backbone
area, or to repair a noncontiguous backbone area. In this example, the ABR R3 has temporarily
lost connection to Area 0 disconnecting Area 2 from the backbone area. The virtual link between
ABR R1 and ABR R2 connects Area 2 to Area 0. Area 1 is used as a transit area.
17.8.1 Terminology
17.8.2 Configurations
R1
DUT# configure terminal Enter the Configure mode.
DUT(config)# interface loopback 10 Specify loopback as the interface you want to configure.
DUT(config-if)# ip address 192.168.1.62/32 Configure the IP address on this interface.