CANOGA PERKINS CanogaOS Configuration Guide - Manual (Page 81)

CanogaOS Configuration Guide
Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 81 of 350
service-provider network on an 802.1Q trunk port.
Two types of 802.1q tunneling are supported: basic 802.1Q tunneling and selective 802.1Q
tunneling.
10.1.2 Basic 802.1Q tunneling Configuration
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-5
Specify the interface (eth-0-5)to be configured and enter the
Interface mode.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)# switchport mode dot1q-tunnel
Configure this interface to dot1q-tunnel port. By default,
dot1q-tunnel port’s type is basic.
DUT1(config-if)#end Exit the Interface mode and enter the Configure mode.
DUT1# show interface switchport interface
eth-0-5
Verify the configuration.
This example shows how to configure a switchport to basic dot1q-tunnel port. You can use
show the configuration on the switchport.
DUT# show interface switchport interface eth-0-5
Interface name : eth-0-5
Switchport mode : dot1q-tunnel(basic)
Ingress filter : enable
Acceptable frame types : all
Default Vlan : 1
Configured Vlans : 1
10.1.3 Selective 802.1Q tunneling Configuration
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# vlan database Enter the VLAN configure mode
DUT1(config-vlan)# vlan 2-10 Create VLAN 2-10.
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-5
Specify the interface (eth-0-5)to be configured and enter the
Interface mode.
DUT1(config-if)#no shutdown Enable the interface.