Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 61)

Note Selecting No enables you to send captured vitals data on
the device before changing profiles. After you complete
that task, if applicable, repeat steps 1 to 3.
Another confirmation dialog appears asking you to confirm the patient and/or
location context information or select a new patient. For example, if both patient
and location context have been established, the following options appear:
• Same patient, same location
• Same patient, different location
• New patient
2. Select the desired option and touch OK.
The profile change immediately takes effect.
5. Touch the Home tab.
You can now start monitoring a patient in the Continuous Monitoring profile.
Pause continuous monitoring (Pause mode)
You can temporarily pause continuous monitoring and retain patient data on the device
when your patient needs to ambulate, use the restroom, or go off the unit for a test.
Note If a low-battery alarm occurs on the device, Pause mode is not available.
Note While in Pause mode, the device retains previously stored patient data, but
it does not display this data or store additional patient measurements until
you exit Pause mode.
1. Touch Pause on the Home tab.
A "Pause" dialog appears, indicating that you have paused continuous monitoring.
Controls on this screen provide options to resume or end monitoring. A countdown
timer displays the time remaining before continuous monitoring resumes.
Note You can configure the Pause Mode timeout in Advanced
settings.
2. To increase the pause interval, repeatedly touch the + symbol until the desired
length of time appears.
The pause interval is automatically applied.
Directions for use Connex CS 55