Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 55)

Diacritical marks key Language(s)
Polish
Greek
1. With the keyboard open, touch the diacritical marks key. This key varies based on
the language, as noted above.
The keyboard displays diacritical marks for the selected language and therefore
varies from one language to another. On each diacritical marks keyboard, the letters
key in the top left corner returns you to the standard keyboard.
2. Touch a diacritical mark.
The keyboard returns to its normal layout.
Close the keyboard
Touch one of the following:
•
Next: Accepts the entry for the current field, then clears the field to allow data
entry for the next field.
• OK: Exits the keyboard and inserts the data.
• Cancel: Exits the keyboard without saving entered data.
Use a barcode scanner
The monitor enables the scanning of patients’ and clinicians’ barcodes to enter ID
information. The barcode scanner supports linear and two-dimensional barcodes.
If you haven't done so already, attach the barcode scanner to the monitor. Use the
instructions to attach an accessory.
Note Refer to the manufacturer's directions for use to ensure that the scanner is
set to USB Com Emulation mode.
1. Remove the barcode scanner from its holder.
2. Hold the scanner approximately 6 inches (15.4 cm) from the barcode and squeeze
the trigger so that the light from the scanner appears on the barcode.
Once the scanner completes a successful barcode reading and any required queries
for a matching ID on the device or in an external host system, the ID appears in the
targeted area (Patient frame, data field, or Device Status area). See additional notes
below.
If the scanner has difficulty reading the barcode, slowly adjust the distance and the
angle between the scanner and the barcode while squeezing the scanner trigger. If it
continues to have difficulty, verify that the barcode is as flat as possible.
Directions for use Using the keypad, keyboard, and barcode scanner 49