Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 175)

Specify advanced SpO2 settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the SpO2 tab.
4. Specify settings.
Setting Action/Description
Default view Select a numeric view or a waveform view as the default
primary SpO2 display on the Home tab.
Default response Select the default speed of response to changes in SpO2
measurements.
Sweep speed default Select the default waveform sweep speed for the SpO2
display in the Home tab.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced tabs and return to the Home tab, touch Exit.
Specify advanced pulse rate settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the Pulse rate tab.
4. Specify settings.
Setting Action/Description
Display source Select this to show the source of pulse rate
measurements (NIBP or SpO2) on the Home tab.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify advanced etCO2 settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
Directions for use Advanced settings 169