Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 176)

b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the etCO2 tab.
4. Specify settings.
Setting Action/Description
Default view Select a numeric view or a waveform view as the
primary etCO2 display on the Home tab.
Display FiCO2 Select to display FiCO2 on the Home tab.
Waveform scale default Select the default waveform scale in etCO2
measurements.
Unit of measure Select primary units of measure for the etCO2 display on
the Home tab.
Check calibration Select to start CO2 calibration check.
Calibrate Select to start CO2 calibration.
Sweep speed default Select the default waveform sweep speed for the CO2
waveform view on the Home tab.
Enable sampling line dialog Select to enable the sampling line dialog to be displayed
when connecting a sampling line to the device.
BTPS compensation Select to enable automatic adjustments for BTPS (body
temperature pressure saturated) to improve the accuracy
of CO2 measurements.
Calibration due hours Displays time remaining until CO2 sensor calibration is
required.
Maintenance due hours Displays time remaining until CO2 periodic sensor
maintenance is required.
Last calibration Displays date (XX/XX/XXXX) and time (00:00:00) of last
calibration.
Annual calibration Displays anniversary date (XX/XX) of annual calibration.
• For more calibration information, see the Service manual.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced tabs and return to the Home tab, touch Exit.
Specify advanced SpHb settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
170 Advanced settings Welch Allyn Connex ® Vital Signs Monitor 6000 Series™